Cleaning method for clogging of drip irrigation equipment

If the drip device does not clean up after a long period of work, it will accumulate more and more impurities, Beijing website production, resulting in equipment blockage.So how do you clean up after a blockage?Drip irrigation equipment manufacturers to tell you next.

1. The most economical and practical method to prevent blockage is the pretreatment of drip irrigation water. The better the pretreatment is, the fewer signs of blockage will occur.According to the water quality and flow, use steel tribulus at the water intake of the pump to make three stops.Or to direct the river to the reservoir, through the sediment reserve, and cover to avoid light, debris access.

2. Precise application of drip irrigation and fertilization. In order to choose the soluble fertilizer, the fertilizer applicator must be installed.However, the equipment can only be used normally. After fertilizing, clean the system with water for 5 minutes to prevent the remaining fertilizer from settling in the pipe.

3. Flush the drip irrigation pipe and clean the filter regularly.When the drip irrigation pipe is first used, clean the end plug, wash off the impurities, and rinse again after 5 times.Check the filter regularly and flush the stain out before irrigation.If filter mesh is damaged, should clean in time.

The above is to give you the introduction of the drip equipment clogging cleaning method, we must follow the above method when cleaning, I hope you can adopt.