Installation of drip irrigation tape
1.Fully check the equipment model, specification, quantity and quality according to the requirements of the design documents, and do not use unqualified products.The equipment to be installed should be kept clean and the plastic pipe should not be thrown, dragged and exposed.
2.Install water meter, valve and filter according to design requirements and flow direction mark.The strainer is connected to the branch pipe through a straight-through threaded connection.
3.The threaded pipe fitting shall be wrapped with raw tape, and the straight-through lock shall be tightened.
4.Before the bypass installation, the holes should be drilled on the branch pipe with a special hole puncher.During drilling, the hole puncher shall not be tilted, and the depth of drill bit into the pipe shall not exceed 1/2 pipe diameter.Then press the bypass into the branch pipe.
5.Cut the drip irrigation pipe (belt) according to the length slightly larger than the plant line, and arrange the drip irrigation pipe (belt) along the plant line, and then connect one end with the bypass.
6.When the drip irrigation pipe (belt) is installed, open the valve and flush the pipe with water, and then close the valve;Place the plug of the drip irrigation pipe (tape) at the end of the drip irrigation pipe (tape);Place the plug on the end of the branch pipe.
7. The installation sequence of the entire drip irrigation system is: valve, filter, straight through, branch pipe, punching, bypass, drip irrigation pipe (belt), flushing pipe and plug.